Watch pagePillsbury Doughboy Talking Watch
Setting and Operating Instructions


Mode
Press B1 (Mode) button to change mode status in a loop as showing in the following.

Time Announcement
Referring to Figure 1, press and release B4 button (Talking) for time announcements.

To Set The Time
In Time-display mode, press B1 (Mode) button once to enter the Time-set mode as indicated by a flashing display. Press B3 (Hour) and B2 (Minute) buttons to adjust the hour and minute respectively until the correct time is obtained.
To Set The Alarm Time
In Time-display mode, press B1 (Mode) button twice to enter Alarm-time-set mode as indicated by a flashing "AL" display. Press B3 (Hour) and B2 (Minute) buttons to adjust the hour and minute respectively until the desired alarm time is obtained.
To Turn On/Off The Alarm
In Time-display mode, press B1 (Mode) button once to enable the Alarm or press B1 (Mode) three times to disable the Alarm.
To Enable/Disable The Hourly Report Function
In Display mode, press B2 button (Hourly Report) to turn on/off the function. When the Hourly-report function is on, a symbol "([{,}])" appears. And the "([{,}])" symbol disappears when the hourly-report function is turned off.
To Change Battery
The watch uses one CR2016 (Lithium) battery. Battery life is estimated to be 18 months based on 5 times of voice playing each day. Follow these steps to replace batteries:
(a) Remove the back cover by loosening the four screws.
(b) Remove the latch on the battery by pushing side way.
(c) Remove the old battery and replace with a new one with its "+" polarity facing up.
(d) Replace the latch.
(e) Replace the back cover.
Note: Do not mix old and new batteries, and do not mix alkaline, standard, or rechargeable batteries.
Attention
If the watch does not operate properly or if the sound weakens or distorts, or LCD display fades, change the battery.


Back to Watch Page - Sue Seibel's Pillsbury Doughboy Collection